| 1. | I have these injection molding cavities coming in , man . check it out
我正准备已经这个新的喷射塑模法，快来看看 |
| 2. | The mold cavity was obtained by splitting mold base in parting surface
模具型腔可采用分型面分割模板的方法获取。 |
| 3. | A 3 - d software designing graphic will be used for mold cavities and sets
3模具制作完成后，可依客户决定到专业试模厂或指定之厂商试模。 |
| 4. | The average velocity result shows the average magnitude of velocity of the polymer inside the mold cavity over time
平均速度?显示塑料在模腔内随时间而变的速度值（平均是指厚度上的平均） 。 |
| 5. | Fang qing ? hua , liang pei ? zhi , li zhi ? gang . optimization of cutting parameters in mold cavity milling j . die and mold technology , 2002 , 2 : 4749
方清华,梁培志,李志刚.模具型腔加工参数的优化问题j .模具技术, 2002 , 2 : 4749 |
| 6. | Results show that the system can shorten the development period of mold cavity design and manufacturing , and promote the development process of mold design and manufacturing
研究结果表明，该系统可以有效缩短模具型腔设计制造周期，加快模具开发的进程。 |
| 7. | When the pressure inside the mold cavity is too great , the mold opening force is greater than its clamping force . then , the mold will be forced to open and cause burr overflow
当塑料在模腔内的压力太大，其分模力大于锁模力，因而迫开工模，就会产生毛边。 |
| 8. | The flow rate , beams result shows the amount and rate of polymer that is delivered through runners into the mold cavity , allowing you to optimize the runner system design
柱体元素流动率?显示柱体元素内塑料的流动率，主要是浇注系统，为优化浇注系统提供依据。 |
| 9. | The mold cavity number is used to group plastic cuvettes at production time ; this helps to ensure the lowest cuvette - to - cuvette variation in extinction coefficient
在生产过程中，通过铸模型腔的数量用来对塑料试管进行分类。这对于确定试管间的最低消光系数很有帮助。 |
| 10. | Aiming at the problem of development period in general mold cavity design and manufacturing process , a feature - based injection mold cavity design and manufacturing system was constructed
摘要针对一般注塑模具型腔设计制造周期问题，构建了基于特征技术的注塑模具型腔设计制造系统。 |
